Shop Detail
Spare parts
- 2/91 Kit: 2 springs
- 2/92 Kit: complete thumb catch assembly with plate, shock absorber
- 2/92B Kit: complete two position thumb catch assembly
- 2/93 Shock absorber assembly
- 7/90 Kit: bolt and nut
- 7/94 Kit: bolt/nut
- 2/9 Toothed nut
- 2/11 Nickel plated spring
- 2/12 Thumb catch
- 2/13 Thumb catch spring washer
- 2/14 Thumb catch screw
- 2/15 Base plate
- 2/16 Toothed segment
- 2/18 Bumper
- 2/19 Crimped ring
- 2/20 Shock absorber
- 2/30 Adjustment key
- 6/35 Blade handle grip
- 7/2 Complete handle assembly without counter blade
- 7/3 Blade
- 7/3-1 Kit: blade, spring, adjustment key
- 7/4 Counter blade with screw
- 7/5B Blade rivet
- 7/6 Counter blade screw
- 7/7 Screw for toothed segment
- 7/8 Bolt
- 7/10 Bushing
- 7/36 Counter blade handle grip
- 8/1 Complete handle assembly without blade
-
-
Kit: 2 springs
2x 2/11 - $4.65
-
Compatible products with FELCO 8
Cleaning
It is advisable to clean your tool after each use. If your tool is particularly dirty or subject to rusting after exposure to moisture, do not delay cleaning.
Oiling
After cleaning, it is advisable to oil the tool so as to protect it from corrosion. The oil will also unjam the tool.
Sharpening
It is advisable to sharpen your tool at least once a day, but if you feel that your tool is not cutting as well as usual, sharpen it right away!
Dismantling
It is advisable to dismantle your tool on a regular basis, but at the very latest when it appears to be jammed.
Changing the anvil-blade
When the blade and anvil-blade no longer cross and the anvil-blade is badly damaged, it is advisable to change it.
Changing the blade
When the blade and the anvil-blade no longer cross, or when the blade is badly damaged, it is advisable to change it. Regulate the working of the blade and anvil-blade by adjusting the tightening of the nut. The blade should rub against the anvil-blade o
Changing the shock absorber
When the tool closes too abruptly during pruning, and the cushion is in good condition, the shock absorber should be changed.
Changing the thumb catch
When the thumb catch is damaged and loosens when used, even when the screw is readjusted, change it.
Changing the plastic coatings for handles
If the coatings are badly damaged, you can replace them. Soak the coatings for 2 minutes in boiling water - recommended glue: Loctite 415.
Our other products
